So, isn't a stainless steel OK to use as the cathode?

----- Original Message -----
From: rob-bac <[email protected]>
> I would like to point
> out that all "lower" metals than silver in CS must be avoided, because
> silver will be plated on them. Probably that could be the same with gold
in
> CG. It has to do with the position in the sequence of potential (in dutch:
> spanningsreeks) in chemistry. The "higher" metal  replaces the "lower"
> metal.
>
> But also materials as PVC (C=Chloride) or sulpher containing compounds
will
> react. (Someone in the group asked a few days ago if CS takes away
fluoride.
> It binds to fluoride, like to chloride, bromide, & iodide. These are the
> halogens and the make badly soluble silversalts. But even they can be
> soluble at extreme low concentration.) Silver also binds to glass!
>
> I used for making CS with 30-40V DC a glass of 330ml, the electrodes hung
> along the inside. After a number of times the glass turned brownish.
Silver
> had been fixed to the wall and could not be removed with polishing powder.
A
> friendly electronic expert told me that that silver layer on the wall
caused
> the current to pass along the wall instead of through the water. To avoid
> that flow of current and timely loss of battery capacity, I now use a
strip
> of hard plastic with two 2mm holes about 3,5 cm apart that holds the two
> electrodes on top of the glass and away from the wall.
> RB



--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>